cement plaster (stucco) wall claddings as specified by ASTM stucco industry standards. Standards ASTM C and ASTM C were carefully researched by. Lathing and furring accessory and fastener installation requirements remain in C as well. This standard does not replace ASTM C violation of the building code IBC and FBC referenced ASTM. C, which establishes the requirements for stucco applied over a metal plaster base a.k.a. lath.
|Published (Last):||15 September 2014|
|PDF File Size:||3.95 Mb|
|ePub File Size:||9.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
These requirements do not aetm default define a unit of work or assign responsibility for contractual purposes, which is the purview of a contract or contracts made between contracting entities. Little can be reached at c. This specification covers the installation of lathing and furring to receive interior and exterior Portland cement-based plaster.
This page can be found at http: He has 20 years of experience asm new product development and technical support, and has also played an integral role in helping shape industry standards for lathing and plastering, as well as installation of masonry stone veneer.
Little is senior product manager at ClarkDietrich Building Systems.
Lathing and furring accessory and fastener installation requirements remain in C as well. The new standard is available and ready at astm. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Work Item s – proposed revisions of this standard.
A New ASTM For Plaster Accessories
It awtm informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
The standard is listed under C The following methods are discussed: Link to Active This link will always route to the current Active wstm of the standard. Since its formation inthe ASTM C11 Stucco Work Group has worked toward reconciling inconsistencies in current standards and creating new standards that reinforce consistency in the stucco industry.
This specification contains the minimum requirements for lathing and furring accessories, fasteners, etc. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The Stucco Work Group meets virtually via webinar and review items that have been proposed, make c163 changes and then develop those into ballot-worthy items for the ASTM committee to vote on a semi-annual basis.
WallsandCeilings – September 2018
With a copyright, the document is not to be duplicated without ASTM permission. Historical Version s – view previous versions of standard.
The following materials shall be used: This abstract is a brief summary of the referenced standard. This new standard will be useful to a wide spectrum of stakeholders, including building owners, specifiers, engineers, architects, manufacturers, and applicators throughout the industry. These were included to provide basic wstm on the shape or appearance of the accessories; both old and new.
Looking forward, the SWG is now developing requirements that will fill the significant needs of building owners, designers, and craftsmen in the stucco industry for the use of continuous insulation and drainage, addressing other important stucco industry topics. Hangers and cold-rolled channel main runner shall conform to the allowable spacing and spans, respectively.